国产精品99久久,欧洲亚洲综合,欧美国产综合在线,国产91精品久久久久久久,成人精品视频一区二区三区,精品一区二区在线

+86-755-23595309

Runic’s products apply in Finger clip oximeter

2022-01-27
Page View:1511
Source:

The Household portable Finger clip oximeter is highly flexible ,can quickly measure the percentage of human blood oxygen saturation (SpO2 ) and pulse rate on the basis of non-injury.Has won wide and high praise and has sold well continuously.

?

As the Hemoglobin in blood has different absorb ability of red light and infrared light.Compare the Hemoglobin? with oxygen (HBO2) and the Deoxygenated hemoglobin(HB) ,HB absorbs more red light and less infrared light, HBO2, on the other hand, absorbs less red light and more infrared. The Red and infrared leds are next to each other in Structurally,thus can allow light pass through in the finger pointed single position conveniently.Light travels from one side of the finger to the other side, after picked up by a photodiode and produce a proportional voltage to it.

?

Runic as a High- tech company with high performance analog signal chain design capabilities, our product line such as OP Amps, Comparator,? Analog Switch, LDO,etc. Can? match very well with the design of? consumer medical products such as? Finger clip oximeter.

?

The typical schematic block diagram of portable Finger clip oximeter is as below:

77.png

In the picture above,the Analog switch RS2105 of Runic is used to switch red LED and infrared LED lamps,they are time-sharing and modulate at a certain frequency. The OP Amp RS321 works with the DAC inside in the MCU to produce a constant current output signal, because the constant-current operation of LED lamp can obtain a relatively stable wavelength, the emission current usually reaches tens of mA, so the on-resistance of analog switch should be less than 1Ω, and the on-resistance of our RS2105 is 0.6Ω, which meets the application requirement well.

?

On the side of the photosensitive receiver, the OP Amp RS622 is used for the photoelectric conversion, which requires the input bias current Ib of the OP Amp to be pA-level, and the?bandwidth of the OP Amp needs to be more than 5 MHZ to satisfy the fast response.The low noise series OP Amp can better to improve the resolution of the system. In the power topology, one is to use two cell dry batteries(3V) boost to 5V and then buck to the system circuit to use, the other is use lithium battery,which can be cycle charged for use.Our low power consumption LDO RS3236 are suitable for both topologies.

?

The main parameters of Runic’s low noise OP Amp RS622 are as below:

?

Wide voltage supply range: 2.5V~5.5V;

?

Low offset voltage:? 0.7mV typical,? 3mVmax;

?

Low temp shift: 2uV/°C typical;

?

Low input bias current IB:1pA;

?

Gain Bandwidth: 7MHz;

?

Quiescent current: 600uA per channel;

?

Noise factor:11nV/√Hz.

?

The main parameters of Runic’s Analog switch RS2105 are as below:

?

Wide voltage supply range: 1.8V~5.5V;

?

Low on-resistance:? 0.6Ω,? 1Ω max;

?

Output current continues:500mA;

?

-3dB Bandwidth30MHz;

?

Quiescent current: less than 1uA;

?

Has MSOP-10TDFN-3*3-10L package for your choice.

?

The main parameters of Runic’s low consumption LDO RS3236 are as below:

?

Wide input voltage range: 1.7V~7.5V, support 4 cells dry battery input application;

?

Internal max output current limit: >500mA;

?

Ultra-low quiescent current: 20uA;

?

Ultra-low drop voltage :1mV/mA;

?

Ultra-high PSRR: 70dB/Hz;

?

Output voltage density optional: 1% or 2.5%;

?

Kinds of fixed -output voltage and many packages such as SOT-23, SOT-89-3, SOT-23-5, UTDFN-1*1-4L for your choice.


主站蜘蛛池模板: 国产国产成人人免费影院| 揉捏女邻居高耸的双乳| 一区二区三区在线视频播放| 69视频网址| 另类视频在线观看| 亚洲免费专区| 成人毛片网站| 日本在线亚州精品视频在线| 成人免费视频无遮挡在线看| 国产在线精品观看| 香蕉久久一区二区不卡无毒影院| 97免费观看视频| 欧美成人v视频免费看| 在线黄色网| 国内精品亚洲| 亚洲精品亚洲人成在线麻豆| 成人精品视频一区二区三区| 日本高清在线播放一区二区三区| 国产h视频免费观看| 国内毛片视频| 亚洲天堂在线视频观看| 国产成人v视频在线观看| 视频在线成人| jizzww| 日本高清一本视频| 国产精品私人玩物在线观看| 免费成人在线观看视频| 怎么下载黄色软件| 精品久久久99大香线蕉| 一二三四视频6+1在线观看免费| 国产成社区在线视频观看| 婷婷色天使在线视频观看| www.色综合| 天天躁夜夜躁狠狠躁| 啊v天堂在线| 婷婷色视频| 国产不卡视频一区二区在线观看| 五月欧美激激激综合网色播| 成人第一页| 香蕉色网| 国产精品热久久毛片|